Everytime Timer

This extremely versatile unit has TWO timer periods. Timer ‘A’ (what happens once the unit is triggered) and Timer ‘B’ (what happens after timer ‘A’ has finished). Operates on any voltage between 12 and 24V DC. Adjustable from 1 second to 64 weeks.

The unit has three basic functions:

• Simple timer, whereby the relay state is changed, either during or after the programmed time following a trigger. This is referred to as A time.
• Cyclic timer, whereby the on and off times of the relay can be separately defined. These times are referred to as A and B times.
• Counting of trigger inputs, whereby the relay state is changed after a set number of trigger pulses have been seen.

Seven modes of operation, edge or level trigger and clean contact. High or low trigger level.

Electrical Operating Conditions

Operating voltage 12 to 24V DC, maximum ripple 2V peak to peak

Reverse power connection indicated by constant red LED

Current drain, relay not active, approximately 10mA, relay active approximately 55mA

Input Levels for Trigger or Reset

LOW: Less than 220 ohms to ground OR an input of less than 0.8 volts

HIGH: Greater than 4700 ohms to ground OR an input of greater than 4 volts

Maximum input voltage 30V

Minimum input voltage -4V

Peak current available from either pin, 5mA

Output Levels

Double pole contacts

AC: Maximum switching voltage 250 volts, maximum current 5 Amps (non inductive load)
DC: Maximum switching voltage 30 volts, maximum current 5 Amps (non inductive load)

Minimum switching level 5V @ 10mA

Environmental Operating Conditions

Temperature range -10°C to +60°C

Maximum humidity 80% non condensing

Dimensions: 100 X 55mm

Packing Weight: 86 grams

Supplied in protective carton with 4 self adhesive fixers & full instructions.